Free · Online · No Install

Water Eject

Remove water from your phone speaker with a free online sound tool. Use sound vibrations to help push water out of your iPhone or Android speaker.

How It Works

How to Get Water Out of Your Phone Speaker

01
Remove your case

Take off any phone case so the speaker is fully exposed.
02
Set volume to max

Set your phone's speaker volume as high as possible before starting.
03
Face speaker down

Hold your phone with the speaker grille pointing downward.
04
Play the sound

Tap Start Water Eject and wait for the full session to complete.
05
Repeat if needed

Run it 2–3 times if the speaker still sounds muffled after the first session.

Tip: Gently shake the phone while the sound is playing to help loosen the water.

Ejection Modes

Choose a Water Ejection Mode

Gentle Mode

Best for a quick splash or light moisture on the speaker grille.

Duration15 sec

Frequency165 Hz

Standard Mode

Best for most water exposure cases. The recommended starting mode.

Duration30 sec

Frequency165–300 Hz

Deep Mode

Stronger sound for muffled speakers with more water inside.

Duration60 sec

Frequency100–200 Hz

When to Use

When Should You Use Water Eject?

Your phone speaker sounds muffled after water exposure
Your iPhone or Android was splashed or dropped in water
Water got into the bottom speaker grille
Audio sounds quieter or distorted than usual
You want to test if sound vibrations help clear the speaker

Limitations

What Water Eject Can and Cannot Do

Can help with

Small water drops in the speaker
Muffled or quieter speaker sound
Light splash or moisture exposure
Speaker grille surface moisture

Cannot fix

Serious internal water damage
A phone that will not turn on
Charging port water damage
Internal corrosion or board damage

If your phone was fully submerged or does not work normally, turn it off and contact a professional repair service.

How It Works

Why Does Water Eject Sound Work?

Phone speakers move air by vibrating. A water eject sound uses repeated low tones and frequency sweeps to create strong movement around the speaker grille. This may help push small drops of water out through the speaker opening.

It works best when:

The water is near the speaker grille
The phone volume is high
The speaker is facing downward
You repeat the sound a few times

Safety

Safety Tips Before Playing the Sound

Do not charge your phone if it is wet
Do not use a hair dryer or heat source
Do not insert any objects into the speaker grille
Do not play the sound with headphones connected
Stop immediately if you hear distortion or unusual crackling

FAQ

Frequently Asked Questions

Is Water Eject safe for my phone?

Yes. It uses standard audio output through your phone speaker at the volume you choose. It does not modify anything on your phone. Do not use it with headphones.

Does Water Eject work on iPhone?

Yes. Open this page in Safari on your iPhone, turn the volume up, hold the phone with the speaker facing down, and tap Start Water Eject.

Does it work on Android?

Yes. It works on Android phones as long as the sound plays through the phone speaker and not through headphones or Bluetooth.

How many times should I play the sound?

Start with one Standard session (30 seconds). If the speaker still sounds muffled, repeat 2 or 3 more times with short breaks between sessions.

What frequency removes water from speakers?

Water eject tools use low-frequency tones, typically around 165 Hz, or frequency sweeps from 100–300 Hz. The exact result depends on your speaker design, water amount, and phone model.

What if my speaker still sounds muffled after using this?

Let the phone dry naturally in a safe, ventilated place for several hours. Avoid charging it while wet. If the sound does not improve, the phone may need professional repair.

Water Eject Online

This free water eject tool helps remove water from your phone speaker using sound. It works directly in your browser and can be used on iPhone, Android, Samsung, and other smartphones.

Start Water Eject